This site uses cookies to help us provide quality services. Using our services, you consent to the use of cookies.

Making a new rear axle!

Since I am still recovering from the plague, I decided to make a rear axle for my Honda PS50 project!

The old axle is a self-made nightmare and I'm sure I can do much better than that. So time to get some material, a lathe and a thread cutter.

IMG 7759

New 12mm~ rod and the old axle.

IMG 7760

Using the lathe to get it exactly 12mm

IMG 7768

Marking the axle where i have to make it a smidge thinner. A smidge.

IMG 7770

Oops. The smidge was a bit too smidge-y. Now I have to start over again. But not today, as energy levels are very very low. What I will do today is testfit the new handle bar and grips!

Please log in or register for free to comment!